HPE JG575A Network Switch Component Networking

Preparing for installation

- The installation procedures must be performed by qualified personnel.
- Before installation, read the compliance and safety manual for the compatible device of the FIPS opacity shield kit.
- Wear an ESD wrist strap, and make sure the wrist strap makes good skin contact and is reliably grounded.
- Make sure the operating temperature is not higher than 40°C (104°F).
- Ensure enough clearance for installation.
- Face the front of the chassis to locate the installation positions (left and right).
- If the device has been mounted in a rack, remove it from the rack

Installing the opacity shield
Only use the screws and hex bolts that are supplied in the opacity shield kit to secure the opacity shield.